» iPad Installation

• Daniel Roberts

  

  • 5 posts
   

  January 16, 2012 5:43:40 PM PST

  How do people get multiple amps running from the single rca outputs of an istreamer? Im going to be running a 4 channel and a mono so 3 pairs are needed.
  
  Cheers in advance
• Justin Bancs

  

  • 42 posts
   

  January 17, 2012 12:59:14 AM PST

  I think most people are running an istreamer into a processor of some sort before going to multiple amps.
• Daniel Roberts

  

  • 5 posts
   

  January 17, 2012 2:24:51 AM PST

  So i run the single rca to the aux input slot of the processor, then i can run the three sets from the outputs?
• Nicholas Frazier

  

  • 219 posts
   

  January 17, 2012 2:32:19 AM PST

  The iStreamer has a SET of RCAs. That goes into one of the inputs on the processor, not AUX.
• Justin Bancs

  

  • 42 posts
   

  January 17, 2012 3:24:44 AM PST

  Yes, you would need something to act as a volume control, and control the sound via eq or crossovers. There are tons out there. Anything from an inexpensive half din eq all the way up to a full blown dsp, like a bit one.
• Daniel Roberts

  

  • 5 posts
   

  January 17, 2012 3:28:12 AM PST

  Which input though? I have front l/r, rear l/r, sub and cener and aux l/r.
  
  With only one set of rca's in and 3 sets out will it still work?
• Daniel Roberts

  

  • 5 posts
   

  January 17, 2012 3:30:36 AM PST

  Its a rockford 3sixty.2 btw so it has a volume control and crossovers :)
• Barry Schanz

  

  • 182 posts
   

  January 17, 2012 3:48:39 AM PST

  I haven't used a 360.2 or an iStreamer, but it looks like your best option is to use the Aux input. The 360.2 should split that off into F/R/Sub/Center outputs. If it doesn't then it's time to read the manual.
• Justin Bancs

  

  • 42 posts
   

  January 17, 2012 3:49:27 AM PST

  In that case I would just run it as aux. I have a bit one, and it just has numbered input, so in my case I have will have my istreamer running to inputs 1 and 2. With such a powerful processor, you should be able to just setup the outputs as you see fit...I would think
• Daniel Roberts

  

  • 5 posts
   

  January 17, 2012 4:14:30 AM PST

  Ill have a look when i get it all wired up. Thanks for the help :)
• Justin Bancs

  

  • 42 posts
   

  January 17, 2012 6:19:13 PM PST

  Good luck with the install.