» General Discussion

• Eddie Logan

  

  • 8 posts
   

  January 9, 2012 10:52:09 AM PST

  Installed Scytek 5000rws and cant find the factory arm and disarm wires?

• Joe Giallombardo

  

  • 42 posts
   

  January 9, 2012 1:33:04 PM PST

  Factory Arm is blue/white to white/red
  Factory Disarm is black/red to white at the drivers door module or most could be at the driver key cylinder also.
• Scott Stott

  

  • 28 posts
   

  January 9, 2012 2:16:17 PM PST

  Ya, you'll have to go in to the driver door, at the switch on a green connector. Both negative wires... but are you not using a data module that controls the factory alarm anyways? The ADS AL-CA bypass will do most of your needed connections through data.
• Chris Lange

  

  • 5 posts
   

  January 9, 2012 6:04:23 PM PST

  I'm sure you checked to see if you even need to hook up arm and disarm by locking the door and manually opening the door. If the alarm goes off then a person then needs to disarm the system. I know on some Honda's when using a fortin or even an ads product it controls door locks only when it's not running. A person then has to hard wire the door locks.